Welcome to Liaocheng Dadi CNC Engineering Co., Ltd.

  中文版       English

一级标题

Your location：Chinese>>English>>News Center
Requirements for DC motors
Requirements for DC motors

2022-11-18

In the servo system, the speed of the motor and the working state should be changed according to the command signal, so the DC motor used in the servo system is called a mass servo motor. According to the role and characteristics of servo in the system, the system puts forward the following requirements for its performance: 1. The corresponding frequency as high as possible also reduces the moment of inertia of the rotor as much as possible, and increases the rotational distance-moment inertia ratio. 2. Good smoot...

Detail
Common problems in CNC retrofit
Common problems in CNC retrofit

2022-11-18

 When inspecting the factory, it was found that there are some problems in the selection of CNC systems: 1. The function selection is not suitable, either the functions of the selected system are far more than the functions required by the transformed machine tool, or some necessary system functions are not purchased. The former will cause cost waste, and the latter will cause a shortage of functions, affecting the use of other functions and buying again. 2. The mismatch between the system grade and the machi...

Detail
Warmly celebrate the opening of the website of Liaocheng Dadi CNC Engineering Company!
Warmly celebrate the opening of the website of Liaocheng Dadi CNC Engineering Company!

2022-11-18

Liaocheng Dadi CNC Engineering Co., Ltd. was established in 1999, mainly carrying out CNC transformation of new and old ordinary machine tools, and began to produce CNC complete machines in 2004, the main models are: 6150, 6136, 6132, 6140, 6125, 630, etc. Now the company's website is open, welcome friends, colleagues, and former industry guidance work.

Detail
Problems in the selection of CNC systems
Problems in the selection of CNC systems

2022-11-18

1. The function selection is not suitable Either the function of the selected system is far more than the function required by the modified machine tool, or some necessary system functions are not purchased, the former will cause cost waste, the latter will cause a shortage of functions, affecting the use of other functions and purchasing at the time.
2. The system grade does not match the machine tool grade. This results in the waste of system functions or the excellent performance of the machine tool cann...

Detail
CNC machine tool operation and maintenance procedures
CNC machine tool operation and maintenance procedures

2022-11-18

CNC machine tool operation and maintenance procedures
1. Clean up the work site before the shift, check the operation handle according to the daily inspection card items, whether the control device is in the shutdown position, whether the safety protection device is complete and reliable, check whether the power supply is normal, and make spot check records.
2. CNC machine tool check lubrication, hydraulic device oil quality, oil quantity, according to the lubrication chart provisions to add oil, kee...

Detail
Home /Company /News Center /Products /Factory /Qualification /Message /Contact us

    Contact us

    Address: No. 6, Zhenyuan Road, Liaocheng High-tech Development Zone
    Postal code: 252000
    Tel.: 0635-8532888 8536066
    Mobile: 13508921389
    Contact: Manager Chen

Liaocheng Dadi CNC Engineering Co., Ltd


  • 扫一扫，进入手机端

  • 扫一扫，关注阿里店铺
Copyright © 2026 Liaocheng Dadi CNC Engineering Co., Ltd All rights reserved.
备案号：ICP备0000000000